Lg Electronics MFL67652408 Istruzione Sull'Installazione

Pagina di 24
Owner's Manual
Laser Display install guide
Please read the safety information carefully before using the product.
www.lg.com
P/NO : MFL67652408(1302-REV00)

Sommario delle specifiche per Miele Lg Electronics MFL67652408

  • Pagina 1Owner's Manual Laser Display install guide Please read the safety information carefully before using the product. P/NO : MFL67652408(1302-REV00) www.lg.com...
  • Pagina 22 Safety Precautions Safety Precautions Please take note of the safety instructions to prevent any potential accident or misuse of...
  • Pagina 3 Safety Precautions 3 yyWhen drilling the holes in the wall, make sure you use a drill and a drill...
  • Pagina 44 PREPARATION PREPARATION Accessories Check the accessories provided with the product. The picture may be different from the actual product....
  • Pagina 5 INSTALLATION 5 INSTALLATION How to fix anchors and screws CAUTION yyCheck the wall materials and the thickness of finishing...
  • Pagina 66 INSTALLATION Installation Procedure (Stand Type) 1 Install the guide pins at the bottom of the set. 2 Connect the...
  • Pagina 7 INSTALLATION 7 3 If the Ez bracket does not stay level, attach a rubber to the bottom of the...
  • Pagina 88 INSTALLATION 5 Attach 390 mm of guide tapes to the top of the table referring the sides of Laser...
  • Pagina 9 INSTALLATION 9 9 Adjust the Ez bracket by following the Laser Display screen adjustment steps to make the size...
  • Pagina 1010 INSTALLATION 10 Place guide tape on both sides of the paper screen in parallel with it. Position the tape...
  • Pagina 11 INSTALLATION 11 14 Mark the end of Ez bracket rod on the wall. (Mark the positions of the holes...
  • Pagina 1212 INSTALLATION 17 Make holes in the two locations marked with arrows using an 8 mm drill. 18 Detach the...
  • Pagina 13 INSTALLATION 13 22 Two people must lift the screen above the guide tape and hang it on the rings....
  • Pagina 1414 INSTALLATION CAUTION • If the screen is tilted when pulling it down, it may not fix to the bracket...
  • Pagina 15 INSTALLATION 15 25 Check that the right and left sides of the screen are parallel to the wall using...
  • Pagina 1616 INSTALLATION If the screen is not parallel to the wall NOTE yyIf the top of the screen is tilted...
  • Pagina 17 INSTALLATION 17 * If the screen is tilted to the right as shown below, fix the left bracket screw...
  • Pagina 1818 INSTALLATION Ez Bracket Adjustment Guide 1. Reset projection  ress the Edge Adj button on the remote control and...
  • Pagina 19 INSTALLATION 19 Insert the hex wrench into the hole as illustrated (left) and turn it clockwise to move the...
  • Pagina 2020 INSTALLATION 4. Adjust the horizontal line of the projection to be parallel with the width of the screen 1...
  • Pagina 21 INSTALLATION 21 5. Adjust the top and bottom widths of the projection so they are equal 1 To narrow...
  • Pagina 2222 INSTALLATION 6. If the projection is rectangle-shaped, 1 Enlarge the projection to fit the screen size Insert the hex...
  • Pagina 23 INSTALLATION 23 7. When the projection is the same size as the screen, fine-tune the projection location using Edge...
  • Pagina 24
downloadlike
ArtboardArtboardArtboard