Canon LV-WX300ST Manuale Utente
63
ENGLIS
H
3.
Remove the lamp cover from the projector.
,
Pull up the lamp cover, pushing up the allow parts of the front
panel.
panel.
•
Do not turn the power on with the lamp cover removed.
•
Do not insert your fingers between the lamp and the
projector. The sharp edges inside the projector may
cause injuries.
projector. The sharp edges inside the projector may
cause injuries.
4.
Remove and dispose of the lamp protection film.
5.
Loosen the screw that secures the lamp.
6.
Lift the handle so that it stands up. Use the handle to slowly
pull the lamp out of the projector.
pull the lamp out of the projector.
•
Pulling it too quickly may cause the lamp to break and
scatter broken glass in the projector.
scatter broken glass in the projector.
•
Do not place the lamp in locations where water might
splash on it, children can reach it, or near flammable
materials.
splash on it, children can reach it, or near flammable
materials.
•
Do not insert your hands into the projector after the lamp
is removed. If you touch the optical components inside,
it could cause color unevenness and distortion of the
projected images.
is removed. If you touch the optical components inside,
it could cause color unevenness and distortion of the
projected images.
7.
As shown in the figure, lower the new lamp into the lamp
compartment while aligning the lamp with the holes in the
lamp compartment. Make sure it fits in the projector.
compartment while aligning the lamp with the holes in the
lamp compartment. Make sure it fits in the projector.
8.
Tighten the screw that secures the lamp.
•
Loose screw may cause a bad connection, which could
result in malfunction.
result in malfunction.
•
Do not over tighten the screw.
9.
Ensure the handle is fully laid flat and locked in place.
1
2
3
1
2
2
3