Sanyo PLC-WXU700 Manuale Utente

⑨  S-VIDEO IN
 Connect the S-VIDEO output signal from video

equipment to this jack (p.18).

⑫

 Connect the audio output signal from video

equipment connected to ⑨ or ⑬ to this jack.
For a mono audio signal (a single audio jack),

connect it to the L (MONO) jack (p.18).

⑪ COMPUTER  1  COMPONENT  /  COMPUTER   

 Connect the audio output (stereo) from a

computer or video equipment connected to ④,
⑤ or ⑥ to this jack. (pp17, 19)

⑬

 Connect the composite video output signal to

this jack (p.18).

④

 Connect output signal from a computer, RGB scart

21-pin video output or component video output to

this terminal (pp.17,19).

⑩

 Connect an external audio amplifier to this jack

(pp.17-19).

 This terminal outputs sound from AUDIO IN terminal

(

⑪ or ⑫).

⑦

 Connect the LAN cable (refer to the owner’s manual

of “Network Set-up and Operation”).

②  USB Connector (Series B)
 In order to operate the computer with the remote

control and use the PAGE

▲▼

buttons on the

remote control during a presentation, connect the

USB port of the computer to the USB terminal with a

USB cable (not supplied) (p.17).

⑧

 Connect the USB menory (refer to the owner’s

manual “Network Set-up and Operation”).

②

③

①

④

⑦

⑧

⑫

⑨

⑪

③  CONTROL PORT
 When controlling the projector with RS-232C,

connect the control equipment to this connector with

the serial control cable.

⑩

⑬

⑤

⑥

①  R/C jACK

When using the wired remote control, connect

the wired remote control to this jack with a remote

control cable (not supplied).

⑥

 Connect the HDMI signal (including sound signal)

from video equipment or the DVI signal from

computer to this terminal (pp.17, 19).

⑤

– Connect computer output to this terminal (p.17).

– This terminal can be used to output the incoming

analog RGB signal and component signals from

COMPUTER IN 1/COMPONENT IN terminal to the

other monitor (p.17).

*  

  is registered trademarks of HDMI

Licensing, LLC.

*