Sanyo PLC-XD2600 Manuale Utente

Filter prevents dust from accumulating on the optical elements inside the projector. Should the filters become

clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup

and adversely affect the life of the projector. If a “Filter warning” icon appears on the screen, clean the filters

immediately. Clean the filters by following the steps below.

Do not operate the projector with the filters

removed. Dust may accumulate on the optical

elements degrading picture quality.

Do not put anything into the air vents. Doing so

may result in malfunction of the projector.

 When using the projector under dusty or smoky conditions,

dust may accumulate on a lens, LCD panels, or optical

elements inside the projector degrading the quality of a

projected image. When the symptoms above are noticed,

contact your authorized dealer or service center for proper

cleaning.

Be sure to reset the Filter counter after cleaning or replacing

the filters.

Press the MENU button to display the On-Screen

Menu. Use the Point

▲▼

buttons to select

Setting and

then press the Point

► or the SELECT

button.

Use the Point

▲▼

buttons to select

Filter counter and

then press the Point

► or the

SELECT button. Use the

Point

▲▼

buttons to select

Filter counter reset and

then press the SELECT button.

Filter counter Reset?

appears. Select

yes to continue.

Reset? appears.

Select

yes, then

another confirmation

box appears.

Select

yes again

to reset the Filter

counter.

Another confirmation dialog box appears, select

yes to

reset the Filter counter.

Turn  off  the  projector,  and  unplug  the AC  power  cord

from the AC outlet.
Remove the panel front assembly by pulling the latch

horizontally.

Remove the panel net by pulling the latch horizontally

and then remove it leftward.

Clean the filters with a brush or rinse them softly.

When cleaning the filters by rinsing, dry them well.

Replace the filters properly. Make sure that the filters

are fully inserted.

 When using the projector under dusty or smoky conditions,

dust may accumulate on a lens, LCD panels, or optical

elements inside the projector degrading the quality of a

projected image. When the symptoms above are noticed,

contact your authorized dealer or service center for

cleaning.

Panel front assembly

Pull horizontally and remove.

Panel net (filter back)

Pull horizontally and then remove it leftward.

✔

Note:

 Please be sure to

fit this edge when

inserting this panel

front assembly.

Spacer filter front

Panel

front