Sanyo PLC-WXE45 Guida Utente

Before calling your dealer or service center for assistance, check the items below once again.

–  Make sure you have properly connected the projector to peripheral equipment as described on pages 14-16.

–  Make sure all equipment is connected to the AC outlet and the power is turned on.

–  When you operate the projector with a computer and it does not project an image, restart the computer.

–  Solutions

–  Plug the power cord of the projector into the AC outlet.

–  See if the POWER indicator lights red.

–   Wait  until  the  POWER  indicator  stops  blinking  to  turn  on  the

projector again. The projector can be turned on after the POWER

indicator turns red (see page 19).

–   Check  the  WARNING  indicator.  If  the  WARNING  indicator  lights

red, the projector cannot be turned on (see on page 54).

–  Check the projection lamp (see page 57).

–   PIN  code  lock  is  being  set.  Enter  a  PIN  code;  the  “1234”  or

numbers you have set (see pages 18, 47–48).

–   Make  sure  "Off"  or  "Countdown  Off"  are  not  chosen  at  Display

function (see page 41).

–   Make  sure  "User"  or  "Off"  are  not  chosen  at  Logo  function  (see

page 42).

–   Make  sure  Input  search  function  is  adjusted  properly  (see  page

44).

–   Check the connection between your computer or video equipment

and the projector (see pages 14-16)

–   See if the input signal is correctly output from your computer. Some

laptop computers may need to be changed the setting for monitor

output  when  connected  to  the  projector.  See  your  computer’s

instruction manual for the setting

–   It takes about 30 seconds to display an image after turning on the

projector.

–   See if the selected system is corresponding with your computer or

video equipment (see pages 26, 36)

–   Select  correct  input  source  once  again  through  menu  operation

(see pages 25 ,34–35).

–   Make  sure  the  temperature  is  not  out  of  the  specified  operating

temperature (

41 ˚F–95 ˚F [5 ˚C–35 ˚C])

.

–   When  "No  Show"  is  operating,  the  image  can  not  be  displayed.

Press  the  NO  SHOW  button  or  any  other  button  on  the  remote

control.

–  Adjust focus of the projector (see page 22).

–   Provide proper distance between the projector and the projection

screen (see page 13).

–  Check the projection lens to see if it needs cleaning (see page 56).

–   Moving  the  projector  from  a  cool  to  warm  place  may  result  in

moisture condensation on the projection lens. If this occurs, leave

the projector off and wait until condensation evaporates.

–   Projecting from the excessive slant angel to the screen may cause

keystone distortion and partial imperfect focus.