Sanyo PDG-DHT100L Manuale Utente

NOTE ON THE POWER CORD

AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.

Projector side

AC Outlet side

To POWER CORD
CONNECTOR on your
projector.

Ground

To the AC Outlet.
(10 V AC)

For Continental Europe

For the U .S .A . and Canada

For the U .K .

To the AC Outlet.

(00–40 V AC)

To the AC Outlet.

(00–40 V AC)

This projector uses nominal input voltages of 100-120 or 200–240

V AC. It is designed to work with single-phase power systems

having a grounded neutral conductor. To reduce the risk of

electrical shock, do not plug into any other type of power system.

If you are not sure of the type of power being supplied, consult

your authorized dealer or service station.

Connect the projector with all peripheral equipment before turning

on the projector.

CAUTION

The AC outlet must be near this equipment and must be easily

accessible.

Connecting the AC Power Cord

Installation

✔

Note:

• Unplug the AC power cord or turn off the MAIN ON/OFF

Switch when the projector is not in use. When the projector
is in stand-by mode, it consumes a little electric power.

Connect the AC power cord to the projector.

Turn the fixing bracket to lock the AC power cord in place.

(See the right figure.)

Fit a fixing bracket in each hole.

A fixing bracket is provided to prevent the AC power cord from

coming loose. Follow these steps to attach the fixing bracket

and connect the AC power cord to the projector.

Fixing

bracket

Holes