Sanyo PLC 8810 Manuale Utente

(Note: Information depends on
System 4

NE

 setup.)

(See note.)

(See note.)

(See note.)

(See note.)

[System 4

NE

 model and software

version displayed here]

If the System 4

 is already configured for a Sanyo PLC projector, go to step 4.

If it is not set up correctly, it will be necessary to change switch settings on the
System 4

 ’s Main Controller Board. Begin at Step 1 to verify the correct

configuration.

1. Use the Front Panel to display the Information Menu to verify that the System 4

is already set up for the Sanyo PLC. Apply power to the System 4

 and do the

following:

a. Press 

 to display the M

ENU

 S

ELECT

 on the LCD screen.

b. Press 

 or 

 to step to Menu 8.

c. Press 

 to select this menu.

d. Press 

 or 

 to display the configuration. The example to the left is general,

yours will show the System 4

 model name, the software version and the

following information:
PRJ = SANYO
PRJ BAUD = 19200
UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)

2. Go to the procedure on page 2-3 of the 

System 4

 User’s Manual to remove the

System 4

 cover. Then go to page 2-4 and refer to the configuration below to

set up the Main Controller board. Continue with Step 3 (below) when the
configuration is correct.

✔

Sanyo PLC

off-on-off-on

0

0

1

E

0

J15

26-467-01

or 26-489-01

3. Double-check your work and be sure the System 4

 cover is on securely.

4. Install the System 4

 in its place of operation (i.e. rack), but not powered on.

__________ Changes in some switch configurations are not detected until the power is

removed at the AC cord, and then restored.

Refer to the following connection diagram and continue.

}