Viewsonic PJD6653WS Manuale Utente

38

To activate the High Altitude Mode:
1.

Press MENU/EXIT on the projector or Menu on 

the remote control and then press 

/

 until the 

SYSTEM SETUP: Advanced menu is 
highlighted.

2.

Press  

to 

highlight 

High Altitude Mode and 

press /

 

to 

select 

On. A confirmation 

message is displayed.

3.

Highlight Yes and press MODE/ENTER on the projector or Enter on the remote 
control.

Operation under "High Altitude Mode" may cause a higher decibel operating noise level 
because of increased fan speed necessary to improve overall system cooling and 
performance.

If you use this projector under other extreme conditions excluding the above, it may display 
auto shut-down symptoms, which is designed to protect your projector from over-heating. 
In cases like this, you should switch to High Altitude Mode to solve these symptoms. 
However, this is not to state that this projector can operate under any and all harsh or 
extreme conditions.

In addition to selecting the projector preset startup screen from among ViewSonic logo, 
Black or Blue screen, you can make your own startup screen that is a picture projected from 
your computer or video source.

To create your own startup screen, project the picture you want to use as your startup screen 
from either a computer or video source. The rest of the steps are as follows.

1.

Press MENU/EXIT on the projector or Menu on the remote control and then press 

/

 until the SYSTEM SETUP: Basic menu is highlighted.

2.

Press 

 to highlight Screen Capture and press MODE/ENTER on the projector or

Enter on the remote control.

3.

A confirmation message is displayed. Press MODE/ENTER on the projector or 
Enter on the remote control again.

4.

The message 'Screen Capturing...' is displayed while the projector is processing the 
picture. Please wait.

5.

If the action is successful, you see the message 'Capture Succeeded' on the screen. 
The captured picture is saved as Screen Capture and the captured picture will be 
displayed as the startup screen if you restart the projector.

In the unlikely event that the capturing action fails, change your target picture. When the 
resolution of the input signal is higher than the projector’s native display resolution (See 

"Projector specifications" on page 64

 for details.), the capture action may fail. When it 

happens, please set the resolution of the input signal under native resolution and try again.