Elmo CRP-26 Manuale Utente

When the projection lamp of the projector reaches its end 

of life, the Lamp replacement icon appears on the screen 

and LAMP REPLACE indicator lights yellow. Replace the 

lamp with a new one promptly. The timing when the LAMP 

REPLACE indicator should light is depending on the lamp 

mode.

Follow these steps to replace the lamp.

For continued safety, replace with a lamp of the 

same type. Do not drop a lamp or touch a glass 

bulb! The glass can shatter and may cause injury.

Allow a projector to cool for at least 45 minutes 

before you open the Lamp Cover. The inside of 

the projector can become very hot.

Unplug the AC power cord. Let the projector cool for at 

least 45 minutes.

Loosen the three (3) screws that secure the lamp. Lift 

the lamp out of the projector by using the handles.

Replace the lamp with a new one and secure the three 

(3) screws. Make sure that the lamp is set properly. 

Close the lamp cover and secure the screw.

Loosen the screw and open the lamp cover.

Connect the AC power cord to the projector and turn 

on the projector.

Lamp

Screw

Handles

Screw

Lamp Cover

Screw

Screw

When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be 

broken.

If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that 

the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the 

lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get 

into your eyes or mouth, seek medical advice immediately.



• When

Mode 2 is selected in the Lamp life control menu, if the projection lamp of the projector reaches its 

  end of life, the lamp replacement icon appears on the screen, and  the projector is turned off automatically 

  after 3 minutes.

  • The Lamp replacement icon will not appear when the Display function is set to 

Off (p.45), during Freeze 

(p.25), or 

No show (p.26).

See "Lamp Counter" on page 55.