Epson 7850p Manuale Utente
32
Using the Remote Control
Activating and Using the Remote
Control
Control
The remote control has an
ON/OFF
switch on its side, as shown.
Before using the remote, make sure batteries are installed as described
on page 34, then push up on the
on page 34, then push up on the
ON/OFF
switch to turn it on.
Turn off the remote control before transporting or storing it; this
prevents the batteries from discharging if something presses against
one of the buttons.
prevents the batteries from discharging if something presses against
one of the buttons.
Here are some additional tips:
■
Point the remote control either at the front or back of the
projector, or at the screen.
projector, or at the screen.
■
Stand within 30 feet of the projector. If you want to operate the
projector from a greater distance, a remote control cable set is
available (see page 14).
projector from a greater distance, a remote control cable set is
available (see page 14).
■
When presenting in a darkened room, press the
light button to
make the buttons on the remote light up temporarily.
■
Avoid using the remote under bright fluorescent lamps or in
direct sunlight, or the projector may not respond properly.
direct sunlight, or the projector may not respond properly.
ON/OFF switch
note
If a button is pressed longer
than 60 seconds, the remote
control stops operating to
conserve power. When you
release the button, normal
operation resumes.
than 60 seconds, the remote
control stops operating to
conserve power. When you
release the button, normal
operation resumes.