Epson EB-X9 Manuale Utente
Sometimes, when the power cable is unplugged, the
t
indicator remains lit for a short period, but this is not a fault.
t
Indicator is lit or flashing red
: Lit
: Flashing
: Off
Status
Cause
Remedy or Status
Internal Error
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address
provided in the Support and Service Guide. s
provided in the Support and Service Guide. s
Fan Error
Sensor Error
Sensor Error
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address
provided in the Support and Service Guide. s
provided in the Support and Service Guide. s
High Temp Error
(overheating)
(overheating)
The lamp turns off automatically and projection stops. Wait for about five minutes. After about five minutes the projector switches to
standby mode, so check the following two points.
• Check that the air filter and Air exhaust vent are clear, and that the projector is not positioned against a wall.
standby mode, so check the following two points.
• Check that the air filter and Air exhaust vent are clear, and that the projector is not positioned against a wall.
If the error continues after checking the points above, stop using the projector, disconnect the power cable from the electrical outlet,
and contact your local dealer or the nearest address provided in the Support and Service Guide. s
and contact your local dealer or the nearest address provided in the Support and Service Guide. s
When using at an altitude of 1500 m or more, set High Altitude Mode to On. s
Lamp Error
Lamp Failure
Lamp Failure
Check the following two points.
• Take out the lamp and check if it is cracked. s
• Take out the lamp and check if it is cracked. s
• Clean the air filter. s
If it is not cracked
: Re-fit the Lamp and turn on the power.
If the error continues
: Replace the Lamp with a new lamp and turn on the power.
If the error continues
: Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or
If it is cracked
: Replace it with a new lamp, or contact your local dealer for further advice. If replacing the lamp yourself, be careful to
When using at an altitude of 1500 m or more, set High Altitude Mode to On. s
Auto Iris Error
Power Err. (Ballast)
Power Err. (Ballast)
Stop using the projector, disconnect the power cable from the electrical outlet, and contact your local dealer or the nearest address
provided in the Support and Service Guide. s
provided in the Support and Service Guide. s
Problem Solving
60