EIKI LC-WB42N Manuale Utente

Filter prevents dust from accumulating on the optical elements inside the projector. Should the filters become

clogged with dust particles, it will reduce cooling fans’ effectiveness and may result in internal heat buildup

and adversely affect the life of the projector. If a Filter warning icon appears on the screen, clean the filters

immediately. Clean the filters by following the steps below.

Do not operate the projector with the filters

removed. Dust may accumulate on the optical

elements degrading picture quality.

Do not put anything into the air vents. Doing so

may result in malfunction of the projector.

 When using the projector under dusty or smoky conditions,

dust may accumulate on a lens, LCD panels, or optical

elements inside the projector degrading the quality of a

projected image. When the symptoms above are noticed,

contact your authorized dealer or service station for proper

cleaning.

Be sure to reset the Filter counter after cleaning or replacing

the filters.

Press the MENU button to display the On-Screen

Menu. Use the Point

▲▼

buttons to select Setting and

then press the Point

►

or the

SELECT

button.

Use the Point

▲▼

buttons to select Filter counter

and then press the SELECT button. Use the Point

▲▼

buttons to select Filter counter reset and then press

the SELECT button. Filter counter Reset? appears.

Select yes to continue.

appears.

Select yes, then another

confirmation box appears.
Select yes again to reset

the Filter counter.

Another confirmation dialog box appears, select yes to

reset the Filter counter.

Turn off the projector, and unplug the AC power cord

from the AC outlet.
Turn the projector over and remove the filters by pulling

the latches upward.

Gently clean the filters by using a brush or rinse it

softly.

When rinsing the filters, dry they well. Replace the

filters properly. Make sure that the filters are fully

inserted to the projector.

Filters
Pull up and remove.