EIKI LC-XBM31 Manuale Utente

63

 Problem:

– Solutions

  No power

– Plug the power cord of the projector into the AC outlet.

 

– See if the POWER indicator lights red.

 

– Wait until the POWER indicator stops blinking to turn on the

projector again. The projector can be turned on after the

POWER indicator turns red. See page 18.

 

– Check the WARNING indicator. If the WARNING indicator lights

 

 red, projector cannot be turned on. See page 58.

 

– Check the projection lamp. See page 61.

 

– Unlock the Key lock function for the projector. See page 53.

The initial display is not shown. – Make sure Off or Countdown off are not chosen at display

 

 function. See page 46.

The initial display is not same – Make sure User or Off are not chosen at Logo (select)

as the default set. function. See page 46.

Input signal switches automatically. – Make sure Input search function is adjusted properly.

(or does not switch automatically) See page 45.

When the projector is on and – That is the Filter warning icon. See page 56.

the Lamp mode icon appears.

An icon other than Input mode – That is the Lamp replacement icon or the Filter warning icon.

or Lamp mode icon appears .           See page 61 or 56.

Image is out of focus.

– Adjust focus of the projector. See page 3.

 

– Provide proper distance between the projector and the

 

 projection screen. See page 13.

 

– Check the projection lens to see if it needs cleaning.

 

 See page 60.

 

– Moving the projector from a cool to warm place may result in  

 

 moisture condensation on the projection lens. In such cases,

 

 leave the projector off and wait until condensation evaporates.

Image is Left/Right reversed.

– Check the Ceiling/Rear function. See pages 35,43.

Image is Top/Bottom reversed.  – Check the Ceiling function. See pages 35,43.

– Check if the

Contrast or Brightness is adjusted properly.

See pages 33, 40.

 

– Check if

Image mode is selected properly. See pages 3, 39.

 

– Check the lamp control function. See pages 5, 5.

 

– Check the LAMP REPLACE indicator. If it lights, the end of lamp

 

 life is approaching. Replace the lamp with a new one promptly.

See page 61.

Before calling your dealer or service center for assistance, check the items below once again.

–  Make  sure  you  have  properly  connected  the  projector  to  peripheral  equipment  as  described  on

pages 14-16.

–  Make sure all equipment is connected to AC outlet and the power is turned on.

– When the projector does not project an image from the connected computer, restart the computer.