Garmin CINEMA 200+ Manuale Utente

5. Loosen the two screws securing the lamp.

6. Grasp the lamp as shown and pull it straight out.

7. Gently insert the new lamp and tighten its screws.

Caution: Don’t touch the glass portion of the lamp assembly. Touching the glass could 
result in premature lamp failure.

8. Replace the cover and tighten its screws. (The projector won’t work if the lamp cover is 

open or loose.)

9. Reset the lamp usage timer, as described in the next section.

After replacing the lamp, follow these steps to reset the lamp usage timer:

1. Press the 

Menu

 button on the projector or remote control.

2. Use the menu navigation buttons to open the 

Reset

 menu, then select 

Lamp-Hours 

Reset

. 

3. When you see a confirmation prompt, highlight 

Yes

 and press the 

button.

4. When you’re finished, press the 

Menu

 button to exit.

The lamp usage timer doesn’t register until you’ve used the lamp for at least 10 hours.

PowerLite Cinema 200+.book  Page 53  Thursday, August 18, 2005  2:37 PM