Infocus LP 600 Manuale Utente
34
Settings menu
Audio
: allows adjustments to the volume and balance, and turns the projec-
tor’s startup Chime on and off.
Sources
:
allows you to assign a particular input to a specific source key
when using the optional Integrator remote. Also allows selection of a
default Power-up Source and enables or disables Autosource.
default Power-up Source and enables or disables Autosource.
Sources>Power-up Source:
this determines which source the projector
checks first for active video during power-up.
Sources>Autosource:
When Autosource is not checked, the projector
defaults to the source selected in Power-up Source. If no source is found, a
blank screen displays. When Autosource is checked, Power-up Source
determines which source the projector defaults to at startup. If no signal is
present, the projector checks the sources in order until a source is found or
until power down.
blank screen displays. When Autosource is checked, Power-up Source
determines which source the projector defaults to at startup. If no signal is
present, the projector checks the sources in order until a source is found or
until power down.
Sources>Monitor Out Enable:
Selects the Computer 2/monitor out con-
nector to be a monitor loop through of the incoming Computer 1 signal
when checked. When it is unchecked, this connector acts as a VESA input.
when checked. When it is unchecked, this connector acts as a VESA input.
System>Rear:
reverses the image so you can project from behind a translu-
cent screen.
Auto Ceiling
: automatically senses when the projector is inverted and turns
the image upside down. This is On by default. When in Ceiling mode, Auto
Keystone is turned off.
Ceiling
Keystone is turned off.
Ceiling
: turns the image upside down for ceiling-mounted projection.
Auto Power
: When Auto Power is checked, the projector automatically
goes into the startup state after the projector is powered on. This allows con-
trol of ceiling mounted projectors with a wall power switch.
trol of ceiling mounted projectors with a wall power switch.
Low Power
: Turn this on to lower the light output of the lamp. This also
lowers the fan speed, making the projector quieter.
Display Messages
: displays status messages (such as “Searching” or
“Mute”) in the lower-left corner of the screen.
Audio
Settings
Sources
Power-up
Source
Source
System