Yamaha LPX-510 Manuale Utente
53
Appendices
Maintenance
1
Turn off the power, wait for the cool-
down period to finish (takes
approximately 30 seconds), then
disconnect the power cord.
down period to finish (takes
approximately 30 seconds), then
disconnect the power cord.
* Wait until the lamp cools down (takes
approximately 1 hour).
2
Loosen the screws fixing the lamp
cover.
cover.
3
Remove the lamp cover.
Lift the lamp cover up slightly from the bottom to
remove it.
remove it.
••••
The lamp replacement warning message is set to appear after approximately 1600 hours
of lamp use in order to maintain the brightness and quality of the projected images. The
time taken for the message to be displayed will vary depending on factors such as the
lamp power setting and the picture mode setting.
of lamp use in order to maintain the brightness and quality of the projected images. The
time taken for the message to be displayed will vary depending on factors such as the
lamp power setting and the picture mode setting.
If you continue to use the lamp after this period, the possibility of the
lamp breaking becomes greater.
lamp breaking becomes greater.
When the lamp replacement message appears, replace the lamp with a new one as soon
as possible, even if it is still working.
as possible, even if it is still working.
••••
The actual life of each individual lamp will vary depending on the characteristics of the
lamp and on the way it has been used. The lamp may become dark or be off even before
the lamp replacement message appears. You should always have a spare lamp ready in
case it is needed.
lamp and on the way it has been used. The lamp may become dark or be off even before
the lamp replacement message appears. You should always have a spare lamp ready in
case it is needed.
••••
Contact your dealer for a spare lamp.
Replacing the Lamp
••••
If the lamp stops working and needs to be replaced, it could have been
broken.
If replacing the lamp of a projector which has been installed to the ceiling,
you should remove the projector from the ceiling before replacing the lamp.
broken.
If replacing the lamp of a projector which has been installed to the ceiling,
you should remove the projector from the ceiling before replacing the lamp.
••••
Wait for the lamp to cool down sufficiently before removing the lamp cover.
It takes approximately one hour after the cool-down period has finished
before the lamp is cool enough to be removed.
It takes approximately one hour after the cool-down period has finished
before the lamp is cool enough to be removed.