Sony STRDN1020 Manuale Utente
31
GB
D:\NORM'S JOB\SONY HA\SO0155\STR-DN1020_PMRF 03\4273051141_GB\GB04GET_STR-
DN1020-CEL.fm
DN1020-CEL.fm
masterpage: Right
STR-DN1020
4-273-051-14(1)
Co
nn
ecti
nn
ecti
on
s
s
Function for conversion of video signals
The receiver is equipped with a function for converting video signals.
• Composite video signals can be output as HDMI video and component video signals.
• Component video signals can be output as HDMI video and composite video signals.
• Composite video signals can be output as HDMI video and component video signals.
• Component video signals can be output as HDMI video and composite video signals.
a : Video signals are output.
– : Video signals are not output.
* HDMI video signals cannot be converted to component video signals and composite video signals.
– : Video signals are not output.
* HDMI video signals cannot be converted to component video signals and composite video signals.
As the default setting, video signals input from the connected equipment are output as shown in the
table above. We recommend that you set the video conversion function to match the resolution of
the monitor you are using. For details, see “Video Settings menu” (page 97).
table above. We recommend that you set the video conversion function to match the resolution of
the monitor you are using. For details, see “Video Settings menu” (page 97).
Notes on converting video
signals
signals
• When video signals from a VCR, etc., are
converted on this receiver and then viewed
on your TV, depending on the status of the
video signal output, the image on the TV
screen may appear distorted horizontally or
no image can be seen.
on your TV, depending on the status of the
video signal output, the image on the TV
screen may appear distorted horizontally or
no image can be seen.
• If you are using an image improvement
circuitry with your VCR, it may impact the
video signal conversion. It is recommended
to turn off this function on your VCR.
video signal conversion. It is recommended
to turn off this function on your VCR.
• Converted HDMI image output does not
support x.v.Color (x.v.Colour), Deep Color
(Deep Colour) and 3D.
(Deep Colour) and 3D.
• The converted video signals are output
through the HDMI TV OUT jack.
• The resolution of the signals output to the
HDMI TV OUT jack are converted up to
1080p.
1080p.
• Set “Resolution” to “AUTO(CVBS)” or
“480/576i” in the Video Settings menu to
output the video signals from the
MONITOR VIDEO OUT, COMPONENT
VIDEO MONITOR OUT jacks when both
are connected.
output the video signals from the
MONITOR VIDEO OUT, COMPONENT
VIDEO MONITOR OUT jacks when both
are connected.
To connect a recording
equipment
equipment
When recording, connect the recording
equipment to the VIDEO 1 VIDEO OUT jacks
of the receiver. Connect cords for input and
output signals to the same type of jack, as
VIDEO OUT jacks do not have an up-
conversion function.
equipment to the VIDEO 1 VIDEO OUT jacks
of the receiver. Connect cords for input and
output signals to the same type of jack, as
VIDEO OUT jacks do not have an up-
conversion function.
Note
Signals output from the HDMI TV OUT or
MONITOR OUT jacks may not be recorded
properly.
MONITOR OUT jacks may not be recorded
properly.
HDMI TV OUT
COMPONENT VIDEO
MONITOR OUT
MONITOR VIDEO OUT
HDMI IN*
a
–
–
VIDEO IN
a
a
a
COMPONENT VIDEO IN
a
a
a
INPUT jack
OUTPUT jack