Casio XJ-S43W Manuale Utente

z During normal use, the lamp and the area around it become extremely 

hot. Before replacing the lamp, turn off the projector and wait for the 
cool down operation (indicated when the POWER/STANDBY indicator is 
flashing amber) to finish. Next, disconnect the AC power cord from the 
projector, and wait for at least 60 minutes to allow it to cool down 
even further.
Touching the lamp or the area around it during operation or 
immediately after turning off the projector creates the risk of serious 
burn injury.

z Replace the lamp using the optional lamp cartridge only.

z A mercury lamp with high internal pressure is used as the light 

source. A lamp that is weakened by impact, damage, or expiration of 
its lamp life may explode or fail to light if exposed to loud noise. Note 
that lamp life differs greatly from lamp to lamp, and is affected by 
conditions under which the lamp is used.

z Never touch the glass of the lamp with your fingers. Doing so can 

cause the lamp to rupture and shorten its life.

z A broken lamp can cause glass fragments to be scattered inside the 

lamp housing. Gas inside of the lamp housing may also be discharged 
from the projector’s vent exhaust ports. Gas inside of the lamp 
includes mercury, so be sure to ventilate the area whenever the lamp 
breaks. Should you accidentally inhale gas fumes or should gas fumes 
get into your eyes, immediately contact a physician.

z Should the lamp break, take care to avoid personal injury on the glass 

fragments. Never try to replace a broken lamp on your own. Be sure 
to contact your original dealer or authorized CASIO service center to 
request replacement.

z The lamp contains mercury. Dispose of old lamps in accordance with 

the rules and regulations of your local jurisdiction.

XJ-S43W Replacement Lamp

YL-4B