Casio pmn Manuale Utente

z Always make sure that the projector has cooled sufficiently before cleaning it. If the 

projector is turned on, perform the following steps before cleaning it.

Turn off the projector.

Check to make sure that the POWER/STANDBY indicator has changed to amber.

Unplug the power cord from the power outlet, and allow the projector to cool down for 
about 60 minutes.

Wipe the exterior of the projector with a soft cloth that has been moistened in a weak 
solution of water and a mild neutral detergent. Be sure to wring all excess moisture from the 
cloth before wiping.
Never use benzene, alcohol, thinner, or any other volatile agent for cleaning.

Carefully wipe the lens with a commercially available lens cloth or optical lens paper, like 
those for eyeglasses or camera lenses. When cleaning the lens, be very careful to avoid 
scratching it.

Carefully wipe the sensors with a commercially available lens cloth or optical lens paper, like 
those for eyeglasses or camera lenses.

Dust and dirt tend to collect around the 
intake vents located on the bottom of the 
projector. Because of this, you should use 
a vacuum cleaner to clean away 
accumulated dust and dirt periodically as 
shown below. When cleaning vents, you 
should set the vacuum clear to its lowest 
power setting.