Casio XJ-A241/XJ-A246* Manuale Utente

Pagina di 56
47
Check the following items whenever you experience any problem with the projector.
POWER
: Amber flashing J 
Red steady
Power has turned off automatically due to a projector memory error. 
Confirm that the POWER/STANDBY indicator is lit red (without flashing). 
After checking the POWER/STANDBY indicator, disconnect the power 
cord from the projector and wait for all of the projector’s indicators to go 
out. Next, reconnect the power cord and turn projector power back on.
If the error occurs again when you turn power back on, contact your 
retailer or nearest authorized CASIO Service Center.
LIGHT
: Not lit or red flashing
TEMP
: Red flashing 
(2-second interval)
Message
: –
POWER
: Amber flashing J 
Red steady
Power has turned off automatically because the light source unit cover is 
open. Perform the following steps.
1 After confirming that the POWER/STANDBY indicator is lit red (without 
flashing), disconnect the power cord from the projector.
2 Check to make sure that the light source unit cover is closed.
3 Plug the power cord back in and turn the projector back on again.
If the error occurs again when you turn power back on, contact your 
retailer or nearest authorized CASIO Service Center.
LIGHT
: –
TEMP
: Amber flashing 
(1-second interval)
Message
: –
Projector Troubleshooting
Problem
Cause and Recommended Action
Power does not turn on.
z If the POWER/STANDBY indicator is not lit, the AC power cord is not connected 
correctly. Connect the AC power cord correctly.
z If the TEMP or LIGHT indicator remains flashing or lit, it means some type of error 
No image is projected or 
the projected image is 
abnormal.
z The computer or video device connected to the projector is not turned on or it is 
not outputting a video signal. Make sure the connected computer or video device 
is turned on, and perform the required operation on it to output a video signal.
z The correct output source is not selected on the projector. On the projector, select 
the correct input source that corresponds to the connected device.
z Images may not project correctly when you have the component output terminal of 
a video device connected to the COMPUTER terminal of the projector. Connect to 
the AV terminal of the projector.
Image color or display is 
very abnormal.
The wrong option (“Component” or “RGB”) may be selected for the “Input Settings J 
COMPUTER Terminal” setting on the setup menu. The image will not be projected 
correctly if “Component” is selected while the projector’s COMPUTER terminal is 
connected to the RGB output terminal of a computer, or if “RGB” is selected while the 
projector’s COMPUTER terminal is connected to the component video output 
terminal of a video device. On the setup menu, select “Auto” for the “Input Settings J 
COMPUTER Terminal” setting. See page 38.
I can’t understand 
messages or menus 
because they are the 
wrong language.
Perform the following operation to select the language you want. See page 40.
1. Press the [MENU] key to display the setup menu.
2. If the input signal is HDMI, press [T] four times and then press the [ENTER] key. If 
the input signal is not HDMI, press [T] five times and then press the [ENTER] key.
3. Press [S] twice and then press the [ENTER] key to display the language selection 
menu.
4. Use the [T] and [S] keys to move the highlighting to the language you want to 
select and then press the [ENTER] key.
5. Press the [MENU] key to exit the setup menu.
Indicator/Error Message
Description and Required Action