Canon BCI-21 Manuale Utente
3
REFILL INSTRUCTIONS FOR CANON
BCI-21/ BCI-24
C
O
L
O
R
DO NOT MODIFY THE CARTRIDGE IN ANYWAY!!!!
PERFORM ALL STEPS OVER SINK
When done refilling a certain color, simply rinse the
syringe out with water and choose your next color.
Syringe does NOT have to be bone dry before refilling
with ink. Just make sure there is no accumulated water
in it.
syringe out with water and choose your next color.
Syringe does NOT have to be bone dry before refilling
with ink. Just make sure there is no accumulated water
in it.
1) Turn the
C
O
L
O
R
INKTANK upside down where the felt
pads on the bottom are facing up towards you. YOU WILL
SEE THREE COLOR PADS.
SEE THREE COLOR PADS.
THE PROCESS FOR REFILLING
THE COLOR IS THE VERY SAME AS THE BLACK EXCEPT
YOU WILL REPEAT IT FOR EACH COLOR.
YOU WILL REPEAT IT FOR EACH COLOR.
2) DRAW UP NO MORE THAN 2cc’S OF THE COLOR YOU WANT TO REFILL.
3) Now, over the sink, Slowly inject the ink...... A FEW DROPS AT A TIME.
3) Now, over the sink, Slowly inject the ink...... A FEW DROPS AT A TIME.
(DO NOT INSERT THE NEEDLE INTO THE SPONGE)
HOLD IT A FEW MILLIMETERS ABOVE
Pause every few seconds so that the sponge can absorb the ink. You can
see the ink as it is pulled down into the chamber. IT WILL ABSORB FAST AT
FIRST THEN SLOW DOWN. THIS “SLOW DOWN” MEANS IT IS GETTING FULL.
Pause every few seconds so that the sponge can absorb the ink. You can
see the ink as it is pulled down into the chamber. IT WILL ABSORB FAST AT
FIRST THEN SLOW DOWN. THIS “SLOW DOWN” MEANS IT IS GETTING FULL.
VERY IMPORTANT:
WHILE INJECTING THE INK INTO THE PAD, WATCH THE
BOTTOM OF THE CARTRIDGE. IF YOU SEE A DROP OR TWO OF
INK.........STOP!!! ITS FULL OR OVER FULL.
INK.........STOP!!! ITS FULL OR OVER FULL.
4)Turn the cartridge right side up. Make sure you are over the sink!!! Look to
see if any ink drops form on the pad. If so, take a paper towel and fold it into
quarters like a handkerchief. Hold it against the pad like a rubber stamp and
let a little ink come out on the paper towel. It should take more than 15 to 20
seconds to do this. When it appears as though no more ink drops will appear,
your done, place back into your printer. 3
see if any ink drops form on the pad. If so, take a paper towel and fold it into
quarters like a handkerchief. Hold it against the pad like a rubber stamp and
let a little ink come out on the paper towel. It should take more than 15 to 20
seconds to do this. When it appears as though no more ink drops will appear,
your done, place back into your printer. 3
NEVER PLACE A DRIPPING CARTRIDGE BACK INTO PRINTER.
Soon, you will become a pro and not have to worry about drips.
You may use immediately after you have finished refilling the cartridge
and
have determined that
NO
ink will be leaking.
THE LAST PAGE DOES NOT APPLY TO THIS CARTRIDGE
3