Lanier CP-282 Manuale Utente

Pagina di 3
 
 
Lanier Worldwide, Inc. 
2300 Parklake Drive, NE 
Atlanta, GA  USA 30345-2979 
MATERIAL SAFETY DATA SHEET 
 
 
 
 
Emergency Telephone:  800-526-4371
 
 
 
Section 1: Chemical Product and Company Information 
 
Identity: 
 
TDC10 Black Toner Cartridge 
 
 
MSDS No. 
 
CP- 282 
Product ID: 
117-0191 
 Issued: 
06/15/2004 
 
Synonyms 
& Common 
Names: 
 
Uses: 
 
Chemical  
Formula: 
 
 
TDC-10 Toner Developer Cartridge 
Black Toner for 
Lanier 6610 
 
Lanier 6610 Copier 
 
 
Mixture  
 Supersedes: 
Date: 
Prepared by: 
Approved by: 
European 
Contact: 
05/08/1995 
06/15/2004 
EH&S Department 770-496-9500 
Larry Choskey, Manager, CEH&S 
Walter Fricke, Manager, Safety & 
Environment,  
Lanier Worldwide, Inc. 
Im Taubental D-41468 Neuss, 
Germany +49-2131-387-177 
Section 2: Composition / Information on Ingredients 
 
Toner Component 
 
Percent 
 
CAS No. 
 
Exposure Limits 
 
Source 
Styrene acrylate copolymer 
92 
25767-47-9 
Not listed 
n/a 
Carbon black 
1333-86-4 
3.5mg/m
3   
3.5mg/m
3
OSHA PEL 
ACGIH TWA 
Organic pigment 
8005-02-5 
Not listed 
N/a 
 
Developer Component 
 
 
 
 
Iron powder 
93.5 
7439-89-6 
Not listed 
N/a 
Carbon black 
0.3 
1333-86-4 
3.5mg/m
3   
3.5mg/m
3
OSHA PEL 
ACGIH TWA 
Difluorethylene polymer 
0.5 
24937-79-9 
Not listed 
N/a 
Styrene acrylate copolymer 
5.5 
25767-47-9 
Not listed 
n/a 
Organic pigment 
0.2 
8005-02-5 
Not listed 
N/a 
 
 
 
 
 
 
 
 
 
 
*PEL as the product:  15mg/m
3
 (total dust), 5mg/m
(respirable dust) 
*TLV as the product:  10mg/m
3
 (total dust), 5mg/m
(respirable dust) 
 
Section 3: Hazards Identification 
HMIS Rating: 
FLAMMABILITY = 1                                                       HEALTH = 1 
REACTIVITY = 0                                                            SPECIAL = none 
 
Health Hazards (Acute, Chronic, Immediate and Potential): Minimum irritation to respiratory tract may occur as with exposure 
to any non-toxic dust. May cause gasping if inhaled.  Inhalation should be avoided.  May cause temporary eye discomfort. 
Health Hazards of Long Term exposure (Chronic): Prolonged inhalation of excessive dust may cause lung damage. It is 
attributed to “lung overloading”, a generic response to excessive amounts of any dust retained in the lungs for a prolonged interval. 
Use of this product, as intended, does not result in inhalation of excessive dust. 
Carcinogenicity:  Carbon Black was reclassified as a Group 2B by the IARC in 1996 based upon the result of only the inhalation 
study in rats. However, there was not observed the incidence of tumors on the test results on dermal or oral studies. Also, 2-years 
inhalation study using a typical toner containing carbon black showed no association between toner exposure and animal tumors. 
Section 4: First Aid Measures 
 
Inhalation: 
Gargle with water. Remove to fresh air if effects 
occur.   Get medical attention if needed.  
 
Eye Contact: 
  
In case of contact, immediately flush eyes 
with water for 15 minutes.  Get medical 
attention if needed. 
Skin Contact: 
Wash with soap and water. 
Ingestion:         Dilute stomach contents with several 
glasses of water.  Get medical attention. 
 Section 5: Fire Fighting Measures 
Suitable extinguishing media:  CO
2
, dry chemical, foam or water. 
 
Extinguishing media which may not be used for safety 
reasons:  none 
 
 
Special protective equipment for fire fighters:  none 
UEL:  n/a                             LEL:  n/a 
  y o u r   d o c u m e n t   m a n a g e m e n t   p a r t n e r