Datamax E-4304 Manuale Utente
20
E-4203/E-4204/E-4304
9) CONTROL CODES
Allows code selection listed in
Programmer’s manual.
Programmer’s manual.
Possible Values:
*
(STD) STANDARD CODES
(ALT) ALTERNATE CODES
10) CONT FORM LENGTH
This command sets the page size (label
length) when the printer’s ‘SENSOR
TYPE’ is set to continuous media.
length) when the printer’s ‘SENSOR
TYPE’ is set to continuous media.
Possible Values:
Range: 0 – 9999; default = *100
Units: .01 inch
Units: .01 inch
11) OOS MAXVOLT
Sets the sensor reading that can
indicate OOS, (out of stock
condition).
indicate OOS, (out of stock
condition).
Possible Values:
Range: 0 – 16; default = *2
Units: 0.1 volt
Units: 0.1 volt
12) TOF GAIN
Sets Top of Form (TOF) Gain value.
Possible Values:
Range: 0 – 15; default = *10
13) TOF DELTA
Sets minimum change in the sensor
reading required to recognize a
“Gap” or Mark”.
reading required to recognize a
“Gap” or Mark”.
Possible Values:
Range: 0 – 50; default = *10
Units: 0.1 volt
Units: 0.1 volt
14) TOF LOW
Sets the minimum sensor reading for
paper (EDGE) or mark (Reflective).
paper (EDGE) or mark (Reflective).
Possible Values:
Range: 0 – 50; default = *0
Units: 0.1 volt
15) LABEL WIDTH
Sets the label width.
Possible Values:
Range: 75 – 410; default = *410
Units: .01 inch
Units: .01 inch
16) Scalable Font
Sets the number of 4K Byte blocks
allocated for scaleable fonts.
allocated for scaleable fonts.
Possible Values:
Range: 0 – 255; default = *64