Xerox 6110 Manuale Utente

Supplies and maintenance items

5.5

Extend the top handle on the imaging unit and then use it 

to pull the imaging unit out of the printer completely.

Take a new imaging unit out of its package. Remove the 

protective devices on both sides of the imaging unit and 
the paper protecting the surface of the imaging unit.

:

• Don’t use sharp objects, such as a knife or scissors, to open 

the imaging unit package. You could damage the surface of 

the imaging unit.

• Be careful not to scratch the surface of the imaging unit.
• To prevent damage, do not expose the imaging unit to light 

for more than a few minutes. Cover it with a piece of paper 
to protect it if necessary.

Holding the handles on the new imaging unit, push the 
imaging unit until it sounds 'click' in to the printer. 

Remove four dummy caps which are on the toner cartridge 
entrances of the imaging unit.

Insert the toner cartridges and waste toner container into 
their corresponding slots until they click into place. 

Close the front cover firmly. 

:

 If the front cover is not completely closed, the 

printer will not operate.

Turn the printer on.

: If there is a 

cracking sound, re-install 
the imaging unit. The 

imaging unit is not 
properly installed.

: Each LED blinks red in a repeated order. Wait for about 

1.5 minutes for the printer to get ready.