Epson 440 Manuale Utente

1.  Removing the upper housing (Refer to section 3.2.1)
2.  Removing the control panel assembly (Refer to section 3.2.3)
3.  Remove 1 screw (No.4) at the right-hand side of the printer mechanism, that fixing “Waste Ink Pad

 Assembly”.

4.  Remove “SPACER, TRAY” fixing “Waste Ink Pad Assembly” at the left-hand side of the printer

 mechanism and remove “Waste Ink Pad Assembly” by pulling it downward.

When you replace “Waste Ink Pad Assembly” to new one, be sure to perform the ink counter reset
operation. (Refer to Chapter 1 / Section 1.4.2 for details)

When re-installing “Waste Ink Pad Assembly”, be sure that “Stopper, Stacker” that attached to the exit
roller shaft is correctly pushed in to back of the projections of “Waste Ink Pad Assembly”.

SPACER, TRAY

Waste Ink Pad Assembly

[Projections]

Section (A)

STOPPER, STACKER

Paper Exit Roller Shaft

Front side

Push it to the back of

projection