Epson 440 Manuale Utente

1.  Removing the ASF. (Refer to section 3.2.5.5)
2.  Remove “TWIST SPRING, 41.2” by unhooking one end from the ASF frame and remove “LEVER,

 BRAKE”.

3.  Remove “BUSH, FIXING, SHAFT” from the right end of “SHAFT, ROLLER, LD” and remove

 “LEVER, HOPPER, RELEASE”.

4.  Move the left paper pack-up assembly to the middle of the ASF and remove “BUSH” from the

 shaft.

5.  Push out “SHAFT, ROLLER, LD” to the left and remove “BUSH, FIXING, SHAFT, LEFT” from the

 left-end of the shaft by unhook it.

6.  Unhook the top of “HOPPER, ASSEMBLY” from the both sides of “FRAME, ASF”.
7.  Push out “SHAFT, ROLLER, LD” to the right while pulling up “PICKUP, ROLLER ASSEMBLY,

 RIGHT” slightly. Then, detach the left end of “SHAFT, ROLLER, LD” from “FRAME, ASF”.

8.  Holds “HOPPER, ASSEMBLY” and remove the right cam part of “HOPPER, ASSEMBLY” through

 the hole at the right side of “FRAME, ASF”.

 
 

To this point, the ASF assembly is disassembled and both left and right “PICKUP, ROLLER ASSEMBLY”

and “HOPPER, ASSEMBLY” are separated.

When removing “HOPPER, ASSEMBLY”, be careful that the grease that applied to the cam part

   of it, is not attaching to other part of the ASF. If so, wipe it off completely.

Make sure that bushes at the both ends of the shaft are firmly attached.

 

 

HOPPER, ASSEMBLY

LEVER, BRAKE

TWIST SPRING, 41.2

BUSH, FIXING, SHAFT, LEFT

FRAME, ASF

LEVER, HOPPER, RELEASE

BUSH, FIXING, SHAFT

SHAFT, ROLLER, LD

BUSH

CAM part