Primera Technology 032910-511262 Manuale Utente

C.

INTERNAL BLUE LED LIGHTS

The Publisher Internal LED lights provide useful light and also

can provide status information.  
By default the lights are set to Flash Enabled.  This condition

will flash the internal LED lights off and on during any error

condition.  A Low Ink Warning error will slowly dim the LED

lights.  The following internal LED light states can be selected

in the PTPublisher software.
- Flash Enabled (Default)
- Always On
- Always Off
To access these settings on a PC go to the Tools Menu -

Options.  To access these settings on a Mac go the the

PTPublisher Menu - Preferences.

D.

TRANSPORTING THE PUBLISHER

To prevent damage to the Publishers robotic arm during 

shipment, it is important to properly secure it.
To prepare for transport, remove the ink cartridges and disc 

holders, close the front cover and then do the following:
1.  With the front cover closed, switch off power to the unit.
2.  Press and hold the Cartridge Button.
3.  While continuing to hold the Cartridge Button, switch on

power to the unit.

Continue to hold the Cartridge Button for five seconds.  After

several more seconds, the robotics will undock and the arm

will lower.  Power will shut off automatically once the robotics

are in transport position.  If you have the cardboard spacer that

was shipped with the unit, replace the spacer inside the unit

and close the cover.  If you don't have the cardboard spacer,

secure the arm and cartridges to the sides of the unit with tape

and close the cover.

511262.qxd  10/15/2009  10:38 AM  Page 54