Printronix P5000LJ Manuale Utente
Serial Submenu
119
TOF Action
•
Reset. A form feed is performed before a warm start when the prime
signal is asserted from the host. This setting is used only if the Prime
Signal parameter is enabled.
signal is asserted from the host. This setting is used only if the Prime
Signal parameter is enabled.
•
Do Nothing. No form feed is performed on reset.
Buffer Size in K
Configures the amount of memory allocated for the Centronics parallel port
buffer. The default is 1 Kbyte, but you can specify between 1 and 16 Kbytes,
in 1-Kbyte increments.
buffer. The default is 1 Kbyte, but you can specify between 1 and 16 Kbytes,
in 1-Kbyte increments.
Serial Submenu
The serial submenu allows you to choose the configuration of the Serial host
interface type, as shown above. Several other serial parameters are included
on this menu, as described below.
interface type, as shown above. Several other serial parameters are included
on this menu, as described below.
Note
The serial parameters in the printer must be set the same as the interface
in the host computer (at the other end of the data cable of the printer).
Otherwise, the printer might not work online, and data characters from the
computer might not print or might print as “garbled” text.
in the host computer (at the other end of the data cable of the printer).
Otherwise, the printer might not work online, and data characters from the
computer might not print or might print as “garbled” text.
Serial
(from page 115)
Interface
Type
Data
Protocol
Baud Rate
Word
Length
Stop Bits
Parity
Data Term
Ready
Request to
Send
Buffer Size in
K
RS-232*
RS-422
RS-422
XON / XOFF*
ETX / ACK
ACK / NAK
DTR
ETX / ACK
ACK / NAK
DTR
9600*
19200
38400
600
1200
2400
4800
19200
38400
600
1200
2400
4800
8*
7
7
1*
2
2
None*
Odd
Even
Mark
Sense
Odd
Even
Mark
Sense
True*
On-Line and BNF
Off-Line or BF
False
On-Line and BNF
Off-Line or BF
False
On-Line and BNF*
Off-Line or BF
False
True
Off-Line or BF
False
True
1*
(1-16)
(1-16)
* = Factory Default