Philips 5900 Manuale Utente

AXIS 5900 User’s Manual

117

Whenever SSL/TLS is enabled, you can only reach the print server’s Web 

interface through the secure services. The unsecure way via http:// is 

closed and now you have to address the print server’s Web interface in 

the secure way, i.e. via https://.

To further increase security, you must disable protocols that are 

considered insecure; 

•

FTP (used by AXIS ThinWizard. If FTP is disabled, AXIS ThinWizard can 
not function properly.)

•

Telnet

•

Auto-IP

•

DHCP

•

BOOTP

•

Remote Config (used by AXIS NetPilot)

•

SNMP Configuration (also used by AXIS ThinWizard. Note that if SNMP 
is disabled, AXIS ThinWizard can not function properly.)

To disable these protocols, go to Admin | Security Settings | Protocol 

Settings | Detailed View and mark the check boxes. Click OK to finish. 

To enable these protocols, select Admin | Network Settings | Detailed 

View | TCP/IP Network for FTP, Telnet, AutoIP, DHCP and BOOTP. 

Remote Config is enabled via Admin | General Settings | RConfig 

Support.

To ensure maximum security, it is highly recommended that you change 

your Administrator password after generating a certificate and disabling 

insecure protocols! This is done from Admin | General Settings | Change 

=> | General | Root Password.

To check SSL/TLS status, open the print server’s Web interface and select 

Admin | Network Settings | Detailed View | TCP/IP Network to see if the 

HTTPS Enabled parameter is set to Yes or No.

To view a Certificate, open the print server’s Web interface, select Admin 

| Security Settings and click View next to the Certificate.

To delete a Certificate, open the print server’s Web interface, select Admin 

| Security Settings and click Delete next to the Certificate.