M-S Cash Drawer 7193 Manuale Utente

7193 Owner’s Guide

Setting Up the Printer

May 1996

Use the wall-mount kit to mount the printer vertically on a wall. See “Ordering
Paper and Supplies” in the chapter, “About the 7193 Printer,” for information on
ordering the printer wall-mount kit.

The kit contains a mounting bracket, screws with plastic anchors, and a label.
Once the printer is mounted on the wall, the operator panel will be upside down.
The label corrects this so the panel can be easily read.

Select a wall that is accessible, but away from main traffic to keep the printer
from being bumped or knocked off. Be sure there are no hidden wires or other
obstructions in the wall where you mount the printer. Keep in mind the length of
the cables when mounting the printer on the wall.

Be sure that the rubber pads have been attached to the bottom of the printer. See
“Attaching the Feet” earlier in this chapter. The rubber pads help the printer to fit
snugly against the mounting bracket.

You will need a 1/4 inch drill bit and either a Phillips or standard screwdriver
(screws are combination Phillips and pan-slotted).

1.  Using the bracket as a template, mark and drill a hole for each plastic anchor

1.25 inches deep.

2.  Insert the anchors into the holes so they are flush with the wall surface and

screw the bracket against the wall, tightening the screws so that the plastic
anchors expand and hold firmly in the wall.

Do not overtighten the screws.

  Because the power cable and communication cable connect to the bottom

of the printer, they must be connected before the printer can be attached to the
bracket. If you haven't connected the cables to the printer, do so now. See
“Connecting Communication and Power Cables” earlier in this chapter.

3.  Line up the tabs of the bracket with the slots on the back of the printer and

attach the printer to the bracket.

4.  Place the label on the cover.