M-S Cash Drawer 7193 Manuale Utente
Diagnostics
7193 Owner’s Guide
May 1996
38
Setting Partial Cut Distance
This function allows you to change the length of the partial knife cut: the higher
the number, the longer the cut.
the number, the longer the cut.
Caution:
The DIP switches are set at the factory to predetermined settings and
should generally not be changed. If you must change the settings, do so carefully
to avoid changing other functions. Run the print test to see what the current
selection is for this function. See “Testing The Printer” On Page 23.
to avoid changing other functions. Run the print test to see what the current
selection is for this function. See “Testing The Printer” On Page 23.
1. Turn the power off.
2. Turn the printer over and note what the current DIP switch settings are.
3. Set the switches to the settings in the table that match the cut distance value
you want (the higher the number, the longer the cut ).
Switch 1
Switch 2
Switch 3
Switch 4
Switch 5
Switch 6
Cut Distance Value
On
On
Off
Off
Off
Off
0
On
On
Off
Off
Off
On
1
On
On
Off
Off
On
Off
2
On
On
Off
Off
On
On
3
On
On
Off
On
Off
Off
4
On
On
Off
On
Off
On
5 (Default)
On
On
Off
On
On
Off
6
On
On
Off
On
On
On
7
4. Turn the power back on to enter the settings into the EEROM.
The On Line light (green) blinks.
5. Turn the power off.
6. Set the DIP switches to the former settings.
DIP switch 1 must be Off to return the printer to the on-line mode.