O'Neil 2TE Manuale Utente

MICROFLASH 2Te PRINTER USER'S GUIDE

If the printer has not been used for a long period of 

time, it may be necessary to recharge the battery. For 

more information, see 

If the battery is low when the printer “wakes up,” the 

printer sounds three short beeps. Plug the AC Adapter 

into an appropriate power source and into the Power 

Port on the printer. The Charge LED will flash and 

progress from red (when the battery is very low in 
power) to orange, and then to a solid green when the 
battery is fully charged. A complete charge takes 
approximately 2.5 to 3.5 hours.

To determine the battery’s condition, print a self-test. 

For more information, see 

. The battery voltage varies between 5.8 and 8.0 

volts.

Note: To obtain full battery capacity, a new battery 

must cycle through two to three complete depletions 

and recharges. 

Note: To restart a charge, unplug the power cord. 

Wait 30 seconds, then replug the power cord. 

Caution: There is a risk of explosion if the battery is 

replaced by an incorrect type. Dispose of used 

batteries according to the instructions.