Genicom cL160 Manuale Utente
Publication No. GEG-99141
Genicom
Apr 02
5-16
GENICOM Intelliprint cL160 User Guide
Fuser Unit
Fuser Unit
5.
Close the front cover.
Fuser Unit
This section describes the procedure for replacing the fuser unit.
NOTE:
To avoid burns, do not replace the fuser unit immediately after printing, as the fuser gets very
hot during this process.
hot during this process.
Replacing the Fuser Unit
Follow the procedure below to replace the fuser unit.
NOTE:
To allow the fuser unit to cool down, turn the printer off for at least 30 minutes before replacing
the fuser unit.
the fuser unit.
CAUTION: To prevent burns, never touch the area marked “CAUTION! HOT!” (fuser area). To
avoid injury or burns, do not use excessive force to remove jammed paper that is difficult
remove or wound tightly around the fuser or rollers. If paper proves difficult to remove, turn
off the printer and contact your Genicom dealer or a Genicom Customer Service Center for
assistance.
To prevent electric shock, always turn off the printer and disconnect the power cord from
the AC outlet before cleaning the printer or performing maintenance.
avoid injury or burns, do not use excessive force to remove jammed paper that is difficult
remove or wound tightly around the fuser or rollers. If paper proves difficult to remove, turn
off the printer and contact your Genicom dealer or a Genicom Customer Service Center for
assistance.
To prevent electric shock, always turn off the printer and disconnect the power cord from
the AC outlet before cleaning the printer or performing maintenance.