Zebra Technologies P640i Manuale Utente
18
P640i Card Printer User Guide
980541-001 Rev. A
Media Handling
Laminating Station
3.
Close the cassette, then pull out a little more laminate. If it
suddenly stops, resisting further pulling, a spring detent on
the cassette, photo below, has snagged a notch on the end
of the core. This means that the core was installed the
wrong way round. If you follow the installation diagram
on the inside of the cassette this won’t happen!
suddenly stops, resisting further pulling, a spring detent on
the cassette, photo below, has snagged a notch on the end
of the core. This means that the core was installed the
wrong way round. If you follow the installation diagram
on the inside of the cassette this won’t happen!
4.
With the white roller up and pointing to your left, rotate
the core counter clockwise to reel in the laminate. Stop
when the end of the laminate is even with the lips of the
cassette - no overhang, but make sure it is not clear of the
white roller (otherwise it won’t feed).
the core counter clockwise to reel in the laminate. Stop
when the end of the laminate is even with the lips of the
cassette - no overhang, but make sure it is not clear of the
white roller (otherwise it won’t feed).
Installing the cassettes
1.
Make sure the laminate is even with the lips of the cas-
sette.
sette.
2.
Insert the cassette into its black molded pocket, then close
the cassette latch (clockwise for the UPER, counterclock-
wise for the LOWER).
the cassette latch (clockwise for the UPER, counterclock-
wise for the LOWER).
3.
Close the main cover. If there was a laminate error before
you replaced the cassette, laminate will automatically feed
from the just-loaded cassette, followed by a cutting action
to free a “patch” of laminate onto the transfer roller. If
laminate does not feed automatically, press the LAMI-
NATE button.
you replaced the cassette, laminate will automatically feed
from the just-loaded cassette, followed by a cutting action
to free a “patch” of laminate onto the transfer roller. If
laminate does not feed automatically, press the LAMI-
NATE button.
Caution • If the end of the laminate is crinkled
or uneven, cut it as square as you can with
scissors, then reel it in.
or uneven, cut it as square as you can with
scissors, then reel it in.
Important •
Check for overhang any time the
cassette latch is opened, or the cassette isremoved.
Cassette
pocket
Cassette
latch