Zebra Technologies RZ400 Manuale Utente
Troubleshooting
Ribbon Problems
Ribbon Problems
122
79695L-003
Z Series
®
/RZ™ Series User Guide
1/11/11
Ribbon Problems
identifies problems that may occur with ribbon, the possible causes, and the
recommended solutions.
Table 18 • Ribbon Problems
Problem
Possible Cause
Recommended Solution
Broken or melted
ribbon
ribbon
Darkness setting too high.
1.
Reduce the darkness setting.
2.
Clean the printhead thoroughly.
The ribbon is coated on the
wrong side and cannot be used
in this printer.
wrong side and cannot be used
in this printer.
Replace the ribbon with one coated on the
correct side. For more information, see
correct side. For more information, see
The printer does not
detect when the
ribbon runs out.
detect when the
ribbon runs out.
The printer was calibrated
without ribbon. Later, ribbon
was inserted without the user
recalibrating the printer or
loading printer defaults.
without ribbon. Later, ribbon
was inserted without the user
recalibrating the printer or
loading printer defaults.
Calibrate the printer, this time using ribbon, or
load printer defaults. See
load printer defaults. See
.
In thermal transfer
mode, the printer did
not detect the ribbon
even though it is
loaded correctly.
mode, the printer did
not detect the ribbon
even though it is
loaded correctly.
The ribbon light is on
even though ribbon is
loaded correctly.
even though ribbon is
loaded correctly.
The printer was not calibrated
for the label and ribbon being
used.
for the label and ribbon being
used.