Zebra Technologies ZM400201101L0T Manuale Utente
Troubleshooting
Calibration Problems
Calibration Problems
108
79695L-001 Rev. A
ZM400/ZM600 User Guide
3/27/07
Calibration Problems
identifies problems with calibration, the possible causes, and the recommended
solutions.
Table 17 • Calibration Problems
Problem
Possible Cause
Recommended Solution
Loss of printing
registration on labels.
Excessive vertical
drift in top-of-form
registration.
registration on labels.
Excessive vertical
drift in top-of-form
registration.
The platen roller is dirty.
Media guides are positioned
improperly.
improperly.
Ensure that the media guides are properly
positioned.
positioned.
The media type is set
incorrectly.
incorrectly.
Set the printer for the correct media type
(gap/notch, continuous, or mark). See
(gap/notch, continuous, or mark). See
The media is loaded incorrectly.
Load media correctly. See
.
Auto Calibrate failed.
Media or ribbon is loaded
incorrectly.
incorrectly.
Ensure that media and ribbon are loaded
correctly.
correctly.
The sensors could not detect the
media or ribbon.
media or ribbon.
.
The sensors are dirty or
positioned improperly. The
sensors are dirty, or media is
positioned improperly for the
sensors to detect.
positioned improperly. The
sensors are dirty, or media is
positioned improperly for the
sensors to detect.
Ensure that the sensors are clean and that media
is positioned properly.
is positioned properly.