Zebra Technologies ZM400201101L0T Manuale Utente

Miscellaneous Printer Problems

3/27/07

ZM400/ZM600 User Guide

79695L-001 Rev. A

 identifies miscellaneous problems with the printer, the possible causes, and the 

recommended solutions.

The language parameter was 
changed through the control 
panel or a firmware command.

1.

Press 

SETUP/EXIT

 to enter configuration 

mode.

2.

Press

 MINUS (-)

.

The printer displays the 

LANGUAGE

 

parameter in the current language. Even if 
you cannot recognize the characters 
displayed, you can still scroll to another 
language.

3.

Press 

SELECT

 to select the parameter.

4.

Press 

PLUS (+)

 or 

MINUS (-)

 to scroll 

through the choices until you find a language 
that you can read.

5.

Press

 SETUP/EXIT

.

The LCD displays 

SAVE CHANGES

 in the 

original language.

6.

Press 

SETUP/EXIT

 again to exit 

configuration mode and save the changes 
(if the language does not change, you may 
need to scroll to a different save option by 
pressing

 PLUS (+)

 or 

MINUS (-)

 in the 

previous step).

7.

Repeat this process, if necessary, until you 
reach the desired language.

The LCD may need replacing.

Call a service technician.

Parameters are set incorrectly.

1.

Set parameters and save permanently. 

2.

Turn the printer off (O) and then on (I).

A ZPL command turned off the 
ability to change the parameter.

Refer to the ZPL Programming Guide, or call a 
service technician.

A ZPL command changed the 
parameter back to the previous 
setting.

Refer to the ZPL Programming Guide, or call a 
service technician.

If the problem continues, there 
may be a problem with the 
main logic board.

Call a service technician.