Zebra Technologies Z6M Manuale Utente
2
Zebra Z4M/Z6M Printers User’s Guide
5HSRUWLQJ'DPDJH
If you discover shipping damage:
•
Immediately notify the shipping company and file a damage report. Zebra
Technologies Corporation is not responsible for any damage incurred during the
shipment of the equipment and will not repair this damage under warranty.
Technologies Corporation is not responsible for any damage incurred during the
shipment of the equipment and will not repair this damage under warranty.
•
Keep the carton and all packing material for inspection.
•
Notify your local Zebra reseller.
6WRUDJH
If you are not placing the printer into operation immediately, repackage it using the
original packing materials. The printer may be stored under the following conditions:
original packing materials. The printer may be stored under the following conditions:
•
Temperature: –40° F to 140° F (–40° C to 60° C)
•
Relative humidity: 5% to 85%, non-condensing
0HGLDDQG5LEERQ5HTXLUHPHQWV
Since print quality is affected by media and ribbon, printing speeds, and printer
operating modes, it is very important to run tests for your applications.
operating modes, it is very important to run tests for your applications.
We strongly recommend the use of Zebra Technologies Corporation-brand supplies for
continuous high-quality printing. A wide range of paper, polypropylene, polyester,
and vinyl stock has been specifically engineered to enhance the printing capabilities of
the printer and to ensure against premature printhead wear.
continuous high-quality printing. A wide range of paper, polypropylene, polyester,
and vinyl stock has been specifically engineered to enhance the printing capabilities of
the printer and to ensure against premature printhead wear.
•
Continuous roll media, fanfold media, or card stock with optional perforations and
registration holes may be used.
registration holes may be used.
•
Printhead life may be reduced by the abrasion of exposed paper fibers when using
perforated media.
perforated media.
•
The ribbon MUST be as wide as or wider than the media being used. If the ribbon
is narrower than the media, areas of the printhead are unprotected and subject to
premature wear. (When printing in direct thermal mode, ribbon is not used and
should not be loaded in the printer.)
is narrower than the media, areas of the printhead are unprotected and subject to
premature wear. (When printing in direct thermal mode, ribbon is not used and
should not be loaded in the printer.)