Zebra Technologies Z6M Manuale Utente

Zebra Z4M/Z6M Printers User’s Guide

71

3ULQW4XDOLW\3UREOHPV

Cutter blade is in the media path.

Turn off the printer power and unplug the printer.  Inspect 
the cutter module for debris and clean as needed following 
the cleaning instructions on page 64.

*There is not enough memory to perform the 
function shown on the second line of the error 
message.

Insufficient DRAM for the label length, downloaded fonts/
graphics, and images.

Ensure that the device, such as FLASH memory or 
PCMCIA card, is installed and not write protected or full.

Ensure that the data is not directed to a device that is not 
installed or available.

You are using an incorrect media and ribbon 
combination for your application.

Consult your authorized Zebra reseller/distributor for 
information and advice.

The printer is set at an excessive print speed 
to achieve optimal quality.

For optimal print quality, set the print speed to a lower 
setting via ZPL II, the driver, or the software.

The printer is set at an excessive darkness 
level to achieve optimal quality.

For optimal print quality, set the darkness level to a lower 
setting via the front panel, the driver, or the software.

The printhead is dirty.

Clean the printhead according to the instructions on 
page 56.

There is light printing (or no printing) on the 
left or right side of the label or the printed 
image is not sharp.

The pressure adjustment dials need to be adjusted.  Follow 
the printhead pressure adjustment instructions on page 65.