Zebra Technologies 7030 Manuale Utente
Maintenance
Firmware
Firmware
104
P1003636-002
TTP 7030™ Technical Manual
10/05/2009
Firmware
The firmware is stored in flash-PROM on the control board. A replacement control board may
not contain the same firmware version that you are currently using, so if you replace the
control board for some reason, upgrade it to the firmware version you want to use.
not contain the same firmware version that you are currently using, so if you replace the
control board for some reason, upgrade it to the firmware version you want to use.
Please visit our web site
http://www.zebra.com
for the most current firmware versions.
Loading
Download the most current firmware version from the Zebra web site
http://www.zebra.com
.
There you will also find the Toolbox utility program (Windows™ software) facilitating the
loading of the firmware into the printer.
loading of the firmware into the printer.
Are you using a Windows environment to load the firmware?
Functions and features are being added from time to time, affecting the firmware in the printer.
The following table lists the changes of general interest. The firmware number is divided into
two sections, the header and the version, separated by a dash.
The following table lists the changes of general interest. The firmware number is divided into
two sections, the header and the version, separated by a dash.
A printer can only be updated with firmware that has the same header as the original number.
The -xxx indicates the firmware version; for example, 330 means firmware version 3.30.
The -xxx indicates the firmware version; for example, 330 means firmware version 3.30.
Note •
We recommend you to design your kiosk system so that remote upgrade of firmware
is possible. If you need to upgrade firmware in the future, the kiosks can be spread over a
vast area and upgrade can become very expensive.
vast area and upgrade can become very expensive.
If…
Then…
No
a.
Send <ESC><NUL> (1BH 00H) to the printer.
b.
Wait 0.5 seconds.
c.
Send the firmware file to the printer.
d.
Wait until the printer buzzes to confirm that the loading is complete (the
presenter motor runs for a second).
presenter motor runs for a second).
Yes
The loader program contains a help file with detailed instructions on how to
load the firmware into the printer.
load the firmware into the printer.
Important •
The loading and burning can take up to one minute. Do not abort before one
minute by turning OFF the power to the printer. Doing so may leave the printer in a state
where new firmware cannot be loaded. If this occurs, please return the printer to a Zebra
authorized service provider.
where new firmware cannot be loaded. If this occurs, please return the printer to a Zebra
authorized service provider.
Printer
Barcode support
Firmware header
TTP 7030
1D barcodes
1856-xxx
TTP 7030
2D PDF-417
1860-xxx
Note •
Specification subject to changes without notice.