DELL 530b Manuale Utente

176

Removing and Installing Parts

Place the system board assembly that you just removed next to the 
replacement system board to compare and ensure they are identical.

Installing the System Board

1 Gently align the board into the chassis and slide it toward the back of the 

computer.

2 Using the screws, secure the system board to the chassis.
3 Replace the cables that you removed from the system board.
4 Replace the processor and the heat sink assembly (see "Installing the 

 

NOTICE: 

Ensure that the heat sink assembly is correctly seated and secure.

5 Replace the memory modules into the memory sockets at the same 

locations from which you removed them (see "Installing Memory" on 
page 126).

6 Replace any add-in cards on the system board. 
7 Replace the computer cover (see "Replacing the Computer Cover" on 

8 Connect your computer and devices to an electrical outlet, and turn them on. 
9 Verify that the computer works correctly by running the Dell Diagnostics 

Replacing the Computer Cover

 

CAUTION: 

Before you begin any of the procedures in this section, follow the 

safety instructions located in the Product Information Guide.

 

CAUTION: 

Do not operate your equipment with any cover(s) (including computer 

covers, bezels, filler brackets, front-panel inserts, etc.) removed.

1 Ensure that all cables are connected, and fold cables out of the way.
2 Ensure that no tools or extra parts are left inside the computer.
3 Align the tabs at the bottom of the computer cover with the slots located 

along the edge of the computer.

4 Press the computer cover down and slide it towards the front of the computer 

until you feel a click or feel the computer cover securely installed.

5 Ensure that the cover is seated correctly. 

book.book  Page 176  Monday, October 6, 2008  11:28 AM