DELL 530b Manuale Utente
196
Appendix
5 Wait for approximately five seconds to clear the password.
6 Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2
6 Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2
and 3 to enable the password feature.
NOTICE:
To connect a network cable, first plug the cable into the network device
and then plug it into the computer.
8 Connect your computer and devices to electrical outlets, and turn them
on.
Clearing CMOS Settings
CAUTION:
Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
1 Follow the procedures in "Before You Begin" on page 105.
NOTE:
The computer must be disconnected from the electrical outlet to clear
the CMOS setting.
3 Reset the current CMOS settings:
a
Locate the 3-pin CMOS jumper (CLEAR CMOS) on the system
board based on your computer model:
board based on your computer model:
•
•
•
•
•
b
Remove the jumper plug from the CMOS jumper (CLEAR CMOS)
pins 2 and 3.
pins 2 and 3.
c
Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1
and 2 and wait approximately five seconds.
and 2 and wait approximately five seconds.
d
Remove the jumper plug and replace it on the CMOS jumper
(CLEAR CMOS) pins 2 and 3.
(CLEAR CMOS) pins 2 and 3.
book.book Page 196 Monday, October 6, 2008 11:28 AM