Apple WS 9650 Manuale Utente

 

 Troubleshooting

Symptom Charts/Hard Drive - 19

 

4 If drive is not initialized, use Drive Setup to initialize.

5 Replace with known-good hard drive. 

6 If hard drive still doesn't work, switch back to original hard 

drive and replace logic board.

Works with internal 

or external SCSI 

devices but not with 

both

1 Verify there are no duplicate SCSI device addresses on a 

single SCSI bus. (Refer to Basics chapter for detailed 

explanation of SCSI IDs used in WS 9650.)

2 Replace terminator on external SCSI device.

3 Verify that SCSI device at end of internal SCSI data cable is 

only device terminated. In PM 8600 or 9600, last connector 

on Fast SCSI-2 cable attaches to rear internal hard drive, 

which is terminated. In WS 9650, Fast SCSI-2 cable should 

have terminator on last connector or last connector should be 

attached to terminated hard drive. On Ultra Wide SCSI-3 bus 

in WS 9650, internal rear drive is terminated and SCSI PCI 

card is auto-terminated. No other devices on the bus should 

be terminated. (Refer to Basics chapter for detailed