Apple 5320CD Manuale Utente

 

 Troubleshooting

Symptom Charts/System - 6

 

Flashing “?” 

appears at startup in 

system with vacant 

PDS and 

communications slots 

1 Diagnose hard drive with Disk First Aid included on Power 

Macintosh CD-ROM.

2 Perform repairs, and then go to step 4.

3 If repairs are impossible, back up drive, reformat with 

Drive Setup 1.0.3, and then go to step 4.

4 Update driver using Drive Setup 1.0.3.

5 Perform clean install of system software.

Flashing “?” 

appears at startup in 

system with version 

B logic board and 

card in PDS or 

communications 

slot 

 

  Version “B” logic boards display a “B” at the end of the 

serial number printed on the board near the communications 

port. (See figure on the next page.)

1 Verify that system software is version 7.5 or later.

2 If chip at logic board location U6 does not include picture of 

Texas and is p/n 343S0138-a, and there is no wire at U27 

on underside of board, replace logic board.