Acer M5811 Manuale Utente

43

Chapter 4

Power-On Self-Test (POST)

Each time you turn on the system, the Power-on Self Test (POST) is initiated. Several items are tested during 
POST, but is for the most part transparent to the user.

       The Power-On Self Test (POST) is a BIOS procedure that boots the system, initializes and diagnoses the 
system components, and controls the operation of the power-on password option. If POST discovers errors in 
system operations at power-on, it displays error messages on screen, generates a check point code at port 
80h or even halts the system if the error is fatal.

NOTE: When Post executes a task, it uses a series of preset numbers called check points to belatched atport 

80h, indicating the stages it is currently running. This latch can be read and shown on a debug 
board.The following table describes the BIOS common tasks carried out by POST. Each task is denoted 
by an unique check point number. For other unique check point numbers that are not listed in the table, 
refer to the corresponding product service guide.

Post Checkpoints List: The list may vary accordingly depending on your BIOS

Before D1

Early chipset initialization is done.  Early super I/O initialization is done including RTC and 
keyboard controller.  NMI is disabled.

D1

Perform keyboard controller BAT test.  Check if waking up from power management 
suspend state.  Save power-on CPUID value in scratch CMOS.

D0

Go to flat mode with 4GB limit and GA20 enabled.  Verify the bootblock checksum.   

D2

Disable CACHE before memory detection.  Execute full memory sizing module.  Verify that 
flat mode is enabled.

D3

If memory sizing module not executed, start memory refresh and do memory sizing in 
Bootblock code.  Do additional chipset initialization.  Re-enable CACHE.  Verify that flat 
mode is enabled.

D4

Test base 512KB memory.  Adjust policies and cache first 8MB.  Set stack.

D5

Bootblock code is copied from ROM to lower system memory and control is given to it.  
BIOS now executes out of RAM.

D6

Both key sequence and OEM specific method is checked to determine if BIOS recovery is 
forced.  If BIOS recovery is necessary, control flows to checkpoint E0.  See Bootblock 
Recovery Code Checkpoints section of document for more information.

D7

Restore CPUID value back into register.  The Bootblock-Runtime interface module is 
moved to system memory and control is given to it.  Determine whether to execute serial 
flash.

D8

The Runtime module is uncompressed into memory.  CPUID information is stored in 
memory.

D9

Store the Uncompressed pointer for future use in PMM.  Copying Main BIOS into memory.  
Leaves all RAM below 1MB Read-Write including E000 and F000 shadow areas but 
closing SMRAM.

DA

Restore CPUID value back into register.  Give control to BIOS POST 
(ExecutePOSTKernel).  See POST Code Checkpoints section of document for more 
information.

E1-E8 EC-EE

OEM memory detection/configuration error. This range is reserved for chipset vendors & 
system manufacturers. The error associated with this value may be different from one 
platform to the next.