Acer R700 Manuale Utente

83

Initial System Startup

Problems that occur at initial system startup are usually caused by 
incorrect installation or configuration. Hardware failure is a less 
frequent cause.

Checklist

•

Are all cables correctly connected and secured?

•

Are the processors fully seated in their sockets on the server 
board?

•

Are all add-in PCI boards fully seated in their slots on the server 
board?

•

Are all jumper settings on the server board correct?

•

Are all jumper and switch settings on add-in boards and peripheral 
devices correct? To check these settings, refer to the 
manufacturer’s documentation that comes with them. If 
applicable, ensure that there are no conflicts-for example, two 
add-in boards sharing the same interrupt.

•

Are all DIMMs installed correctly?

•

Are all peripheral devices installed correctly?

•

If the system has a hard disk drive, is it properly formatted or 
configured?

•

Are all device drivers properly installed?

•

Are the configuration settings made in BIOS Setup correct?

•

Is the operating system properly loaded? Refer to the operating 
system documentation.

•

Did you press the system power on/off switch on the front panel to 
turn the server on (power on light should be lit)?

•

Is the system power cord properly connected to the system and 
plugged into a NEMA 5-15R outlet for 100-120 V (or a NEMA 6-15R 
outlet for 200-240 V)

•

Is AC power available at the wall outlet?

•

Are all integrated components from the tested components lists? 
Check the tested memory, and chassis lists, as well as the supported 

BS811.f/cppl!!Qbhf!94!!Uvftebz-!Opwfncfs!37-!3113!!21;19!BN