Blade ICE G8124-E Manuale Utente
BLADEOS 6.5.2 Application Guide
50
Chapter 2: Initial Setup
BMD00220, October 2010
Setup Part 5: Final Steps
1.
When prompted, decide whether to restart Setup or continue:
Enter
y
to restart the Setup utility from the beginning, or
n
to continue.
2.
When prompted, decide whether you wish to review the configuration changes:
Enter
y
to review the changes made during this session of the Setup utility. Enter
n
to continue
without reviewing the changes. We recommend that you review the changes.
3.
Next, decide whether to apply the changes at the prompt:
Enter
y
to apply the changes, or
n
to continue without applying. Changes are normally applied.
4.
At the prompt, decide whether to make the changes permanent:
Enter
y
to save the changes to flash. Enter
n
to continue without saving the changes. Changes are
normally saved at this point.
5.
If you do not apply or save the changes, the system prompts whether to abort them:
Enter
y
to discard the changes. Enter
n
to return to the “
Apply the changes?
” prompt.
Note –
After initial configuration is complete, it is recommended that you change the default
passwords as shown in
Would you like to run from top again? [y/n]
Review the changes made? [y/n]
Apply the changes? [y/n]
Save changes to flash? [y/n]
Abort all changes? [y/n]