Emerson RTM-ATCA-7150 Manuale Utente

ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)

 

Emerson Network Power Embedded Computing (ENPEC) and our suppliers take significant 
steps to ensure there are no bent pins on the backplane or connector damage to the boards 
prior to leaving the factory. Bent pins caused by improper installation or by inserting boards 
with damaged connectors could void the ECC warranty for the backplane or boards.

 

Incorrect installation of the product can cause blade damage.
Only use handles for when installing/removing the product to avoid damage/deformation to 
the face plate and/or PCB

 

Damage of the Product
The RJ-45 connector(s) on the face plate are either twisted-pair Ethernet (TPE) or E1/T1/J1 
interfaces. Connecting an E1/T1/J1 line to an Ethernet connector may damage the product.

z

Make sure that TPE connectors near your working area are clearly marked as network 
connectors. 

z

Verify that the length of an electric cable connected to a TPE bushing does not exceed 100 
meters.

z

Make sure the TPE bushing of the product is connected only to safety extra low voltage 
circuits (SELV circuits).

If in doubt, ask your system administrator.

This product is a Class 1 laser product. The use of controls or adjustments or performance of 
procedures other than those specified herein may result in hazardous radiation exposure.

Always dispose of used blades, system components and RTMs according to your country’s 
legislation and manufacturer’s instructions.