Emerson ATCA-7150 Manuale Utente

ATCA-7150 and RTM-ATCA-7150 Getting Started (6806800G42B)

7. Insert RTM-ATCA-7150 with the GE daughter card installed in the shelf. For more 

information refer, 

After installation, check if RTM-ATCA-7150 can be powered on and work normally. Use the 
network cable to connect RTM-ATCA-7150 to the external network. Check if the network is 
connected properly and monitor whether the network port indicator is normal.

To replace the GE daughter card, proceed as follows.

1. Wear the ESD-preventive wrist strap. For more information refer, 

2. Remove the RTM-ATCA-7150 whose GE daughter card is to be replaced. For more 

information refer, 

.

3. As shown in step 1 of the figure below, open the plastic latches fastening the GE 

daughter card.

4. Exert even force upwards until the daughter card connector is removed from the 

connector on RTM-ATCA-7150. As shown in step 2 of the figure below, remove the 
daughter card by facing the daughter card at an angle of 45° to the RTM.

5. Place the removed GE daughter card in an antistatic package.