Rosewill HIVE-750 Manuale Utente
POWER SUPPLY
All rights reserved by Rosewill
5
Installation
• Please make sure the power supply is not connected to the AC power cord.
• Make sure the I/O switch of the PSU is at off “O” position.
• Install the power supply into the chassis. (refer to your chassis manual)
• Please refer to your motherboard user manual to confirm 20-pin or 24-pin main
connector it needs. If 24-pin, you can plug the 24-pin main connector onto the
motherboard. If 20-pin, please detach the 4-pin to have a 20-pin main connector
then plug it onto the motherboard.
• Please refer to your motherboard user manual to confirm 4-pin ATX12V or
8-pin EPS12V connector it needs. If 8-pin, you can plug the 8-pin EPS12V connector
onto the motherboard. If 4-pin, please detach the 4-pin to have a 4-pin ATX12V
connector then plug it onto the motherboard.
• Connect the PCI-E connector to the VGA card if needed. Please refer to VGA card
manual to confirm 6-pin or 8-pin needed.
• Connect the SATA connector to the SATA HDD, Optical device if any.
• Connect the Molex connector to devices such as Optical device,
HDD, fan…etc.
• Connect the Floppy disk connector to the floppy drive if any.
• Please connect the other side of the cable to the PSU according to the instruction
on the PSU
• Make sure all the connectors are fully seated.
• Connect the AC power cord to the power supply.
• Turn on the power supply by pushing the I/O switch to the “I” position.
• Make sure the I/O switch of the PSU is at off “O” position.
• Install the power supply into the chassis. (refer to your chassis manual)
• Please refer to your motherboard user manual to confirm 20-pin or 24-pin main
connector it needs. If 24-pin, you can plug the 24-pin main connector onto the
motherboard. If 20-pin, please detach the 4-pin to have a 20-pin main connector
then plug it onto the motherboard.
• Please refer to your motherboard user manual to confirm 4-pin ATX12V or
8-pin EPS12V connector it needs. If 8-pin, you can plug the 8-pin EPS12V connector
onto the motherboard. If 4-pin, please detach the 4-pin to have a 4-pin ATX12V
connector then plug it onto the motherboard.
• Connect the PCI-E connector to the VGA card if needed. Please refer to VGA card
manual to confirm 6-pin or 8-pin needed.
• Connect the SATA connector to the SATA HDD, Optical device if any.
• Connect the Molex connector to devices such as Optical device,
HDD, fan…etc.
• Connect the Floppy disk connector to the floppy drive if any.
• Please connect the other side of the cable to the PSU according to the instruction
on the PSU
• Make sure all the connectors are fully seated.
• Connect the AC power cord to the power supply.
• Turn on the power supply by pushing the I/O switch to the “I” position.
128mm
188mm